Black Carpet Edition Pan Car Body Support

Posted by Denis Schablowski on

BLACK CARPET EDITION 1/12 Body Support

The CRC Black Carpet has many great advantages over the old gray carpet and the ETS carpet, like the high consistent grip level, less tire wear, more forgiving with 1/12 tire choices and so on.

But with many things in life there are also some draw backs. Most of them only need some adjustments in driving style and setup, but some of them are more hidden and can result in a suddenly uncontrollable car. I’m talking about the body scrub of 1/12 pan cars in high speed corners and on the straightway. I know that sounds like a major issue because the body could be mounted higher, but that will increase the drag and lower the downforce of the body. This body scrub is usually not caused from a body that is mounted too low. It is generated by the air going over the body and bending the nose down until it touches the surface. The outcome of this is a reduced top and corner speed, and it can even lift the front wheels off the track. This will result in a huge crash. 

The 1/12 Body Support is designed to tackle this problem by supporting the nose of the body.
Our part will reduce the body scrub to a bare minimum and allows to mount the body lower than a conventionally mouted body. Our testing has proven that the average and fastest lap times dropped when the body support was installed.

 The 1/12 Body support is available in two versions made from 1mm Lexan. These versions are 35 and 60-degree. The 35-degree version is designed for a body with a low angled nose like the AMR and the 60-degree version is made to support a body with a short nose like the BMR. Thank you for reading and see you at the track,
Your West Coast R/C Works team
(https://www.westcoastrcworks.us)


Share this post



← Older PostNewer Post →